DC Brush Series Wound Motor for Hydraulic Pump and Hydraulic System and Lift

DC Brush Series Wound Motor for Hydraulic Pump and Hydraulic System and Lift

DC Brush Collection Wound Motor for CZPT Pump and CZPT Method and Raise

PG36M555 Collection

voltage: 3VDC 6VDC 9VDC 12VDC 24VDC
Speed variety: 3000-9500rpm
electrical power: three.3-13w
Typical apps: Central air-conditioning valve, Amusement gear, Coin
Refund products, Grill, Oven, Peristaltic pumps, ATM financial institution
Automatic system, Robot, Healthcare gear, Workplace
Tools, House appliances, Automatic actuator.
Excess weight: 320~400g/PCS(approx)
Packing details: CTN measurement: 32X28XH26cm 40PCS/CTN G. W. 16Kgs

 

Gearbox info:
 
Number of stages 1stages reduction 2 stages reduction three stages reduction four levels reduction five phases reduction
Reduction ratio three.seventy five.two 13.719.226.nine 50.971.299.5139 188264369516721 6699771367191126723736
gearbox length ” L” mm 26.4 32.6 38.9 forty five.three 52.five
Max.Working torque three.0Kgf @ cm 6.0Kgf @ cm eight.0Kgf @ cm 12.0Kgf @ cm 20Kgf @ cm
Max. Gear breaking torque 9.0Kgf @ cm eighteen.0Kgf @ cm 24Kgf @ cm 36Kgf @ cm 60Kgf @ cm
Max. Gearing effectiveness ninety% eighty one% 73% sixty five% 59%
    Motor information:
 
Motor name Rated volt.v No load Load torque Stall torque
Recent Velocity Present Velocity Torque Output power Torque Present
mA r/min mA r/min gf @ cm W gf @ cm mA
RS-555123000 12 ≤140 3000 ≤800 2200 a hundred and fifty 3.3 600 3000
RS-555124500 12 ≤220 4500 ≤1200 3300 220 seven.two 880 7800
RS-555126000 12 ≤350 6000 ≤2000 4500 three hundred 13.5 1200 6000
RS-555243000 24 ≤70 3000 ≤400 2200 150 3.3 600 1600
RS-555244500 24 ≤110 4500 ≤600 3300 220 seven.two 880 3000
RS-555246000 24 ≤180 6000 ≤1000 4500 300 thirteen.5 1200 4000
       1This table lists some motors parameters, other folks remember to refer to specific parameters of  rs-555.htm”
       2Afier connecting motor and gearbox which is named gearmotor the output torque:motor torque X reduction ratio X        gearing efficiencyoutput velocity:motor pace / reduction ratio.
    NOTE:
   1 Gearmotor named techniques: e . g . SG-555123000-99.5K    Motor make sure you refer to the motor information RS-555123000.
          Gearbox remember to refer to gearbox knowledge reduction ratio99.five .Connected to gearmotor output velocity and torque please 
          refer to motor knowledge. 
   2 Motor can be put in wiht magnetic encorder. encorder parameters make sure you refer to  me-37.htm .
   3CZPT output shaft following lowering: eight.0mm. other measurements of then output shaft can make as consumer ask for.
   4Chart only for reference,merchandise shall prevail the entity.

Firm Introduction

 

DC Brush Series Wound Motor for Hydraulic Pump and Hydraulic System and Lift

Tags: